How do you winterize an inboard boat motor?

How to Fully Winterize Inboard Boat Motors in 4 Steps

1. Prepare Your Inboard Boat Motor for Winterizing. Fill the tank with gas.
2. Add Antifreeze and Spraying Fogging Oils. After your motor is cleaned and prepared as described above, the first real winterization step is applying antifreeze.
3. Change the Engine's Oil and Replace Oil Filter.
4. Do a Final Inspection.

.

Simply so, how do you winterize an inboard boat with antifreeze?

Start the engine and run at idle until antifreeze discharges from the exhaust outlet for 30 seconds or more. When the bucket is nearly empty, begin fogging the carburetor, as with the sterndrive. Spray plenty of the mist in while the engine coughs and complains, and turn the ignition off when the antifreeze runs out.

Beside above, how much antifreeze Do I need to winterize my boat? To winterize the engine with antifreeze, you'll need a five-gallon bucket, and enough antifreeze for your engine and related plumbing (at least two gallons).

Consequently, what are the steps to winterize a boat?

Steps

• Flush the engine with fresh water.
• Stabilize your fuel.
• Fog the engine cylinders and carburetor intakes.
• Flush your engine block with antifreeze.
• Change the oil.
• Drain and replace the gear case lubricant.
• Disengage the battery and store it in a safe, dry place for the winter.

How can I keep my boat warm in the winter?

Electric boat heaters can be used in the cabin to warm the living space or in the engine compartment to keep the engine warm and dry. Just make sure to get the right one for the job, as cabin heaters and engine compartment heaters (also called bilge heaters) have different uses and features.

Related Question Answers

Do you need to put antifreeze in an outboard motor?

RE: Do you need antifreeze in an outboard? No need to. Keep the motor in the full down position and all the water will drain out. Keep it that way all winter so water does not get in behind the prop and freeze.

Do I need to winterize an outboard motor?

If your engine has a fogging oil fitting, you do not need to remove the air box cover. Four-stroke outboards have a plastic air intake that you spray the fogging oil into. Fuel stabilizer in a size to treat your fuel tanks.

Do you need to fog a 4 stroke outboard?

4 Strokes really don't need to be "fogged" ,,which the true definition of "fogging " is spraying storage oil into the intake while the engine is running to coat all the moving parts with oil.

How much does it cost to winterize a boat?

The Cost of Paying to Have Your Boat Winterized As noted above, the average cost of having a professional winterize your boat for you is about $300. That price is an aggregate of a wide range of costs, so we need to look at some more specific examples of boat winterization costs in order to give a more accurate quote.

How do you fog a boat engine?

Fog the carburetor intake(s) Before the engine runs out of fuel, spray fogging oil into the carburetor(s). Fogging oil is an anticorrosive that will protect the internal surfaces of the carburetor and the cylinders.

Can I use RV antifreeze in my boat engine?

In addition to providing protection against freeze damage, some antifreeze can also be used as a coolant for running engines. Due to its slightly lower cost, some boaters prefer to use our Seafit Brand Marine and RV Water System Antifreeze, which is a propylene glycol/alcohol blend.

Will my boat engine freeze?

If you have an engine that is raw water cooled in freshwater from like a lake or a river and water is left in your lines, then the temperature would have to fall below 32 degrees Fahrenheit for several hours. A boat left in the water overnight should be okay. The surrounding water will keep it from freezing.

What happens if you don't winterize your boat?

If You Don't Winterize Your Boat, Here's What Happens. Water freezes and expands and can damage anything it's trapped inside. Water may seep into unprotected spaces to do this. Acidic and corrosive wastes, salt and corrosion buildup can damage delicate parts in engines.

How do I winterize my sterndrive?

Here are the other key steps to winterizing a sterndrive.

1. Drain Residual Water. First, run the engine on a flusher and get it up to operating temperature so that the thermostat opens.
2. Fill with Antifreeze Solution.
3. Drain/Replace Gear Lube.
4. Check the Prop Shaft.
5. Inspect Everything.

How do you drain antifreeze from a boat engine?

Pour RV antifreeze directly into the thermostat opening or into the large hose attached to it. Keep pouring until you see a steady stream of the pink stuff running out of the block drain plug. Tip the trailer up (so it drains well) and place a bucket under the hull drain plug. Then remove the plug (Photo 3).

How do you start an inboard boat engine?

Make certain the boat has been placed in the water so the intake water pump can pick up cooling water. Turn the key and wait until the engine catches and runs. Let the engine run slightly above idle for several minutes, then gradually raise the throttle. If the engine runs smoothly without missing, you can launch.

What is the difference between RV antifreeze and marine antifreeze?

Most RVers are savvy enough to know there's a huge difference between RV antifreeze and automotive antifreeze. RV antifreeze is non-toxic and meant for pumping into the plumbing system. Automotive antifreeze is a whole different critter. Many types are toxic, and should only be put into an engine cooling system.

How do I winterize my boat air conditioner?

The Winterization Process

1. If your boat is in the water, start by removing the hose from the discharge thru hull port and run it into an empty one-gallon bleach or antifreeze bottle.
2. Fill the Engine Winterizing Kit tank with two gallons of antifreeze solution.

How long does it take to winterize a boat?

It takes me about 4 hours to winterize. That's draining the ballast system and blowing out all the lines for the heater and shower plus all the engine stuff like oil change and filling with coolant. The wash and wax are done by a friend before it goes away and then just a cover.

Can you run a boat motor without water?

Flushing a boat motor by running it out of water is a routine maintenance task. Running the engine without a water source for any length of time will cause damage, so you'll need to attach a hose to the motor's water intakes. If your motor doesn't, you'll need a set of motor flusher muffs.

How do you store a boat outside in the winter?

How to Prepare Your Boat for Winter Storage

1. Use a Cover. Cover your boat to keep it from dirt and moisture.
2. Change Oil.
3. Spray Fogging Oil.
4. Lubricate the Steering Device.
5. Replenish the Coolant.
6. Take out the Drive Belts.
7. Detach the Battery.
8. Conceal Exhaust Ports on Inboard Boats.

Do you have to winterize your boat?

Boats kept ashore must be winterized, and it must be done earlier than if they were in the water because dropping temperatures will affect them sooner. Wherever you end up keeping your boat, if you do not plan to use it for a month or more, you need to winterize it.

How do you winterize?

Steps for Winterizing Your Plumbing

1. Shut off the main water valve, and then turn off the water pump and the water heater.
2. Open all drain valves and all taps.
3. Using air compressors, blow excess water out of the pipes.
4. Open the drain valve in your hot water tank and let it discharge until it is empty.

How do you use fogging oil?

Keep the engine running for about ten seconds after you've sprayed the fogging oil, and then shut it off. If you want a little more protection for the engine, you can also apply fogging oil to the cylinders behind the spark plugs. Just pull out every spark plug so you can spray the fogging oil onto each cylinder.